Casting break-even calculator
Compare a part machined from bar or billet with the same part made as a casting. Enter two quoted prices, or build the cost up from weights and machining times. The example shown is a real quotation with its prices indexed.
Read the working behind it in When a Casting Beats Machining from Solid.
Cumulative cost by parts made
Show the chart as a table
Cost per part
Get a quoted figure
Send us your drawing and specification and we will return a budgetary quotation within three working days.
Your drawing is sent to Bruynseels Ltd and used only to prepare your quotation. You can also email it to info@bruynseels.co.uk. Open an email with these figures
This is an estimate for comparing two routes. The build-up leaves out setup time per batch, scrap rate, inspection per part and stock holding. Example figures are not a quotation.
How the sum works
The calculator compares the cost of one part on two routes. Machined from solid, you pay for the stock, less the scrap value of the swarf, plus the machining time. As a casting, you pay for the casting plus the machining of its functional faces. The difference is the saving per part.
Break-even quantity = tooling cost ÷ saving per part
Tooling is paid once, so a casting wins only when demand is high enough to repay it. Enter two quoted prices if you have them. If you have no casting quote yet, build the cost up from weights and machining times. Our article "When a casting beats machining from solid" explains the reasoning and the cases where machining stays the better route.